What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 26.06.2025 05:27
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
But it can get overloaded, and no longer works.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
nine
One is “what exactly is in a ‘surge protector’ ? ”
Why are black people seen as scary or a threat to some people?
This device then solves the entire problem.
These are simplified answers to the original question, and does not change anything I wrote above.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
the problem then depends on "how fast does the fuse operate?".
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
An AC voltage/ current source, and an ac inductive load.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
He then describes Rainy Season and Lightning.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Do you think there will ever be peace in the Middle East as long as Israel exists?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
He then asserts :
The third is lightning and “how it gets conducted into a home.”
Davante Adams feels rejuvenated: Joining Rams was "exactly what I needed" - NBC Sports
Because the load is inductive, the current lags the voltage.(by a bit).
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
I post the exact comment here.
Bonnie Blue Permanently Banned From OnlyFans Over 'Extreme' Content - okmagazine.com
It seems Mohan does not understand the difference between a comment and an Answer.
The other is “what does a “fuse” do?”
Upvotes:
'Razor blade throat', a stabbing pain, might hint at infection from new Covid strain - WION
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
It also is a device that limits the change in current flow.
2024–10–10[John johnson John Johnson ]
Bitcoin Price Rises. This Could Be the Next Big Crypto IPO After Success of Circle Stock. - Barron's
What is lightning?
eight
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
What was the worst thing that ever happened on live TV?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[image of Common-mode choke]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
a photo is worth a thousand words.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Barnstars:
Now when you have a certain ac resistance, then a current flows in a loop.
There are three different concepts here that are getting confused.
This is 'the assistant's answer'
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
but I think this circuit , shows a few more pieces.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
so, what happens?
He then describes the function of a fuse.
What does a fuse do?
(Dc diagram shown, AC is similar).
This is where this question deviates from being a 'generic' question, and becomes more specific.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
but this device (an Inductor) … impedes the rapid changes in the current.
The bolt then partially travels down the line to your home.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
what exactly is a ‘surge’ protector?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
A fuse is a non-resetable over current circuit protector.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
For this case there are devices called Metal oxide varistors (MOV).
At one ohm, the resistor has a maximum of 1 watt power.
This is where the MOV conducts again, and dissipated the energy.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
There are two important concepts here.
Edit 2024–10.
In schematic diagrams this is the symbol for a fuse:
2024–10–16 [ OO OLAOYE OYEBODE ]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
So, the voltage could go up to 500 volts, and the fuse will not open up.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–14 [Omar Gharbi Omar Gharbi ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The MOV will conduct when the voltage exceeds 50% of line voltage.
A circuit breaker is similar, but is resettable.
First Sentence:
One
These devices are installed between the “hot” and “neutral” and protective ground.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This one hit behind the barn.
[old diagram got deleted by accident]
At least they know the answer if they wanted it.
Here is a simplified AC power diagram.